This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HA Unit

nabil.alwan2004 over 10 years ago

Hi all,

I want to have a failover UTM but in an office connected to us by Fiber Optic Cable (LAN Connection), so should I connect both units by direct cables or through a VLAN for their HA ports?

And thanks in advance.

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 10 years ago

You want to connect with direct cables.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 10 years ago

You want to connect with direct cables.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 PeterRL over 10 years ago in reply to Scott_Klassen

Hi Scott,

i also will have that configuration to perform on a network that has two sites (and the idea is to install the second UTM over that remote site).

Our idea was precisely to have a vlan connecting the two HA interfaces (from each UTM). According to your last comment, this is not supported?

Thank you in advance.
Cancel
Vote Up 0 Vote Down

Cancel

HA Unit

Submitted a Tech Support Case lately from the Support Portal?