This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM 9 for class A network not working properly

Hello,

i have the attached network topology .

Now i cannot access the other networks from the class A network (10.0.1.0). I would like to enter the Gigaset T300 VoIP PBX System with my IP telephones.

The 192. network is working properly.

Any hints? [:S]

Best regards,
Rome

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 10 years ago

Have you created the rules to allow the traffic to pass between subnets? Is 10.0.1.1 set as the default gateway for the phones? As Barry asked, do the logs show the traffic being dropped?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 10 years ago

Have you created the rules to allow the traffic to pass between subnets? Is 10.0.1.1 set as the default gateway for the phones? As Barry asked, do the logs show the traffic being dropped?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

UTM 9 for class A network not working properly

Submitted a Tech Support Case lately from the Support Portal?