This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Allow TCP option on UTM-9 Appliance

Hello,

We have a UTM-9 appliance running firmware 9.206-35. We are busy installing and configuring WAN accelerator hardware.

We need to have the UTM-9 appliance to accept TCP options for the WAN accelerator to work.

Does anyone have experience with enabling this option? How can we enable this option on the appliance?

Kind regards,

Gerard

This thread was automatically locked due to age.

Parents

0 BAlfson over 10 years ago

I think you're out of luck with the UTM, Gerard, but you should check with Sophos. You might want to vote for MPTCP (MultiPath TCP) / WAN Bonding / Multilining.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 10 years ago

I think you're out of luck with the UTM, Gerard, but you should check with Sophos. You might want to vote for MPTCP (MultiPath TCP) / WAN Bonding / Multilining.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Allow TCP option on UTM-9 Appliance

Submitted a Tech Support Case lately from the Support Portal?