When monitoring traffic flow I refer to: Interfaces on the Dashboard Flow Monitor (clicking on the interface in the dashboard) Note they use different units to report: Interfaces shows Mbps or kbps Flow Monitor shows MB/s (i.e. Mbps x 8) Its always nice to be able to compare like against like. Searched forum and knowledge base but wasn't able to find a previous thread for possible fix or workaround. Does anyone know of a workaround or fix? Thanks in advance for any suggestions.

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Traffic flow monitoring inconsistency

darcym over 10 years ago

When monitoring traffic flow I refer to:

Interfaces on the Dashboard
Flow Monitor (clicking on the interface in the dashboard)

Note they use different units to report:

Interfaces shows Mbps or kbps
Flow Monitor shows MB/s (i.e. Mbps x 8)

Its always nice to be able to compare like against like. Searched forum and knowledge base but wasn't able to find a previous thread for possible fix or workaround. Does anyone know of a workaround or fix?

Thanks in advance for any suggestions.

This thread was automatically locked due to age.

0 Scott_Klassen over 10 years ago

Beyond changing the dashboard interfaces between Mbps and kbps by editing each interface (under advanced), there isn't any other configuration setting for flow monitor. You'd be best served by creating a feature request at UTM (Formerly ASG) Feature Requests: Hot (1974 ideas).

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Traffic flow monitoring inconsistency

Submitted a Tech Support Case lately from the Support Portal?