This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SNMP Query : Value of request

hello,
i read this post :https://community.sophos.com/products/unified-threat-management/astaroorg/f/53/t/33331

i use UTM 220 v9.208-8
i have a internet symetric link 4Mbits/s (arround 4.5M/4.5M) on eth1 in my UTM 220.
when i search value in MIB, i have two values :
IF-MIB::ifOutOctets.3 = 3593588622
IF-MIB::ifInOctets.3 = 896985420

what is unit of numbers ?
i divided these numbers by 8 (octet), but result have no signification for me.

thx for answer.

This thread was automatically locked due to age.

0 nord-avenir over 10 years ago

ok, i find.
the value is the total of octet receive by this interface.
it isn't a value in intreface at one time.

i search the value in interface IN/OUT at one time.
is it possible ?

thx for awser
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 10 years ago

Hi, if you don't find it, you'll need to periodically check it and divide by the time elapsed to get the current bandwidth usage.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

SNMP Query : Value of request

Submitted a Tech Support Case lately from the Support Portal?