This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using UTM with 3rd party IDS

As an MSSP partner, we've sold a couple of SG310s to a customer, along with the IDS and SEIM we offer through another technology partner. Ideally, the IDS would jack into a span port. Is there a way to configure one of the unused interfaces on the SG to be a span port, so that all traffic is monitored by the IDS?

This thread was automatically locked due to age.

Parents

0 BarryG over 10 years ago

You can possibly use a bridged interface, but it depends on how many interfaces and networks you have.

Personally I've bought TAPs before from NetOptics, but if you have good switches it's often cheaper to use them.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 10 years ago

You can possibly use a bridged interface, but it depends on how many interfaces and networks you have.

Personally I've bought TAPs before from NetOptics, but if you have good switches it's often cheaper to use them.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Using UTM with 3rd party IDS

Submitted a Tech Support Case lately from the Support Portal?