This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using UTM with 3rd party IDS

As an MSSP partner, we've sold a couple of SG310s to a customer, along with the IDS and SEIM we offer through another technology partner. Ideally, the IDS would jack into a span port. Is there a way to configure one of the unused interfaces on the SG to be a span port, so that all traffic is monitored by the IDS?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 10 years ago

This is not possible with UTM, you would have to do so with switches.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 10 years ago

This is not possible with UTM, you would have to do so with switches.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Using UTM with 3rd party IDS

Submitted a Tech Support Case lately from the Support Portal?