This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Flow monitor not showing Outward bandwidth usage

We have a 2Mbit outbound connection that for some reason is being saturated. Clicking on this in the 'Out' section of Dashboard brings up the flow monitor, but as far as I can tell, it is only showing inwards usage.

If I'm wrong, how can I tell what is the source IP that is causing the outbound traffic?

Running Release 9.201-23

The device's CPU utilisation is about 63%, RAM 52%.

Thanks,

James.


This thread was automatically locked due to age.
Parents
  • Use the 'Bandwidth Usage' tab of 'Logging & Reporting >> Network Usage' to identify the source.  About four years ago, BrucekConvergent identified a problem with Yahoo because it won't accept an email larger than 10MB, but doesn't reject the email - it just lets the sending server try over and over again.

    Cheers - Bob
Reply
  • Use the 'Bandwidth Usage' tab of 'Logging & Reporting >> Network Usage' to identify the source.  About four years ago, BrucekConvergent identified a problem with Yahoo because it won't accept an email larger than 10MB, but doesn't reject the email - it just lets the sending server try over and over again.

    Cheers - Bob
Children
  • Use the 'Bandwidth Usage' tab of 'Logging & Reporting >> Network Usage' to identify the source.  About four years ago, BrucekConvergent identified a problem with Yahoo because it won't accept an email larger than 10MB, but doesn't reject the email - it just lets the sending server try over and over again.  Cheers - Bob
      

    Hi Bob, that log doesn't separate outbound and inbound traffic, which is what I need to figure out what is saturating my ADSL upload. Any other suggestions?

    Thanks, James.