This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM 9.x vLan setup

I have a UTM setup and working fine except for vlan's. As soon as I change the internal nic from "Ethernet Static" to "Ethernet vlan" I loose connection to the UTM device. If I just try to add a new interface, the "hardware" field is empty. Nothing to select. How in the &*$*#$^ do you setup vlan's on this thing?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 11 years ago

When setting up VLANs, you really need to connect to the UTM from a separate interface to do so, as when you switch from ethernet standard to VLAN, you will lose connectivity from any machine connected to that interface whose traffic isn't being tagged for the VLAN. Do you have a switch that will be doing the tagging? How many hardware interfaces (NIC ports) do you have on the box?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 11 years ago

When setting up VLANs, you really need to connect to the UTM from a separate interface to do so, as when you switch from ethernet standard to VLAN, you will lose connectivity from any machine connected to that interface whose traffic isn't being tagged for the VLAN. Do you have a switch that will be doing the tagging? How many hardware interfaces (NIC ports) do you have on the box?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 edisoninfo over 11 years ago in reply to Scott_Klassen

Why does the switch need to tag anything at this point? The internal nic should be vlan 1 which is the default untagged un-anything vlan. When I create vlan2 it will be tagged but vlan1 should be left alone.
Cancel
Vote Up 0 Vote Down

Cancel

UTM 9.x vLan setup

Submitted a Tech Support Case lately from the Support Portal?