Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Beginner Question: Multipath Rules & QoS

Hi Guys,

I am just an amateur (so excuse the post), and starting to really like the features of Sophos UTM.

But because I'm not a professional I really do find it hard to understand how to operate it correctly. I can read the user manual but without live examples I find it very hard to relate to my (personal) setup.

I have got two WANS and one LAN.  The WANS are slow ADSL connections which is all we can get here.  Auto balancing is enabled.  Off it I am running 10 PCs, a Voip server , 5 Cisco voip handsets, 6 smart phones, 2 laptops, and a partridge in a pear tree.

My troubles are as follows:

Question
I have to configure a multpath rule so VOIP only runs through one of the WANs.  I dont understand "what to put where" in the multipath rules. A bit of advice would be appreciated.   I'm running a VOIP PBX called 3CX on PC 192.168.1.2 and it uses ports 5060(sip) and also 9000:9014 (rtp) to operate, and it has to go down one wan, not both or either.

Pls advise correct parameters for the multipath rule:
SOURCE:?
SERVICE: (I assume the port)?
DESTINATION:?
ADVANCED: BALANCE TO: (assume WAN1)?



Thanks guys -you're the best. [:)]

Cheers
Noddy


This thread was automatically locked due to age.
2013-05-28 21_06_25-Microsoft Excel - wan & QOS config.zip
Parents Reply Children
  • All rules sets are applied in sequence.  When a rule is matched, no further rules in the rule set are considered.

    Cheers - Bob


    Cheers Bob - 

    Q1 Ok so Rule 1 is highest priority (top of list) ?

    Q2, to clarify,

    My first rule is to bind my voip service group (5060, 9000:9014) to Wan 1, then the next rule in the list has a contradicting command - it say to forward (all)ports 1: 65535 to Wan2.

    Are you saying that this second rule won't over ride the first rule, in other words the second rulewill bind ports 1:5059 & 5061:8999 & 9015:65535 to Wan 2, leaving the Voip ports alone (on Wan 1) as rule 1 set them out ?