Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Beginner Question: Multipath Rules & QoS

Hi Guys,

I am just an amateur (so excuse the post), and starting to really like the features of Sophos UTM.

But because I'm not a professional I really do find it hard to understand how to operate it correctly. I can read the user manual but without live examples I find it very hard to relate to my (personal) setup.

I have got two WANS and one LAN.  The WANS are slow ADSL connections which is all we can get here.  Auto balancing is enabled.  Off it I am running 10 PCs, a Voip server , 5 Cisco voip handsets, 6 smart phones, 2 laptops, and a partridge in a pear tree.

My troubles are as follows:

Question
I have to configure a multpath rule so VOIP only runs through one of the WANs.  I dont understand "what to put where" in the multipath rules. A bit of advice would be appreciated.   I'm running a VOIP PBX called 3CX on PC 192.168.1.2 and it uses ports 5060(sip) and also 9000:9014 (rtp) to operate, and it has to go down one wan, not both or either.

Pls advise correct parameters for the multipath rule:
SOURCE:?
SERVICE: (I assume the port)?
DESTINATION:?
ADVANCED: BALANCE TO: (assume WAN1)?



Thanks guys -you're the best. [:)]

Cheers
Noddy


This thread was automatically locked due to age.
2013-05-28 21_06_25-Microsoft Excel - wan & QOS config.zip
Parents
  • Ok.  Been having a few problems with multipath rules not doing what they should be, i must have a misconfiguration issue.

    I have a few that are playing up, but thought best to discuss one at a time.

    RULE 1.
    I want all devices on my network in the IP range 192.168.1.3 to 192.168.1.200 to bind soley to Wan2.


    Now i created a new network definition with the address range of 192.168.1.3 to 192.168.1.200 and called it 'all devices except server'.  (my server is 192.168.1.2)

    Problem is when I try to add this in the multipath rule (under source or destination) , it won't add.

    What should the rule be?

    cheers guys.
Reply
  • Ok.  Been having a few problems with multipath rules not doing what they should be, i must have a misconfiguration issue.

    I have a few that are playing up, but thought best to discuss one at a time.

    RULE 1.
    I want all devices on my network in the IP range 192.168.1.3 to 192.168.1.200 to bind soley to Wan2.


    Now i created a new network definition with the address range of 192.168.1.3 to 192.168.1.200 and called it 'all devices except server'.  (my server is 192.168.1.2)

    Problem is when I try to add this in the multipath rule (under source or destination) , it won't add.

    What should the rule be?

    cheers guys.
Children
No Data