Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Beginner Question: Multipath Rules & QoS

Hi Guys,

I am just an amateur (so excuse the post), and starting to really like the features of Sophos UTM.

But because I'm not a professional I really do find it hard to understand how to operate it correctly. I can read the user manual but without live examples I find it very hard to relate to my (personal) setup.

I have got two WANS and one LAN.  The WANS are slow ADSL connections which is all we can get here.  Auto balancing is enabled.  Off it I am running 10 PCs, a Voip server , 5 Cisco voip handsets, 6 smart phones, 2 laptops, and a partridge in a pear tree.

My troubles are as follows:

Question
I have to configure a multpath rule so VOIP only runs through one of the WANs.  I dont understand "what to put where" in the multipath rules. A bit of advice would be appreciated.   I'm running a VOIP PBX called 3CX on PC 192.168.1.2 and it uses ports 5060(sip) and also 9000:9014 (rtp) to operate, and it has to go down one wan, not both or either.

Pls advise correct parameters for the multipath rule:
SOURCE:?
SERVICE: (I assume the port)?
DESTINATION:?
ADVANCED: BALANCE TO: (assume WAN1)?



Thanks guys -you're the best. [:)]

Cheers
Noddy


This thread was automatically locked due to age.
2013-05-28 21_06_25-Microsoft Excel - wan & QOS config.zip
Parents
  • You can edit service definitions at 'Definitions & Users >> Services' or, you can just click on the green "+" beside 'Service' in the Multipath rule, change 'Type of Definition' to "Group" and drag-n-drop the SIP and RTP definitions into the group.

    You might want to read through the sections on WebAdmin and the Dashboard in the Manual which you can download in the 'Support' section.  All of us need to be reminded to RTFM occasionally! [;)]

    Cheers - Bob
Reply
  • You can edit service definitions at 'Definitions & Users >> Services' or, you can just click on the green "+" beside 'Service' in the Multipath rule, change 'Type of Definition' to "Group" and drag-n-drop the SIP and RTP definitions into the group.

    You might want to read through the sections on WebAdmin and the Dashboard in the Manual which you can download in the 'Support' section.  All of us need to be reminded to RTFM occasionally! [;)]

    Cheers - Bob
Children
No Data