Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Beginner Question: Multipath Rules & QoS

Hi Guys,

I am just an amateur (so excuse the post), and starting to really like the features of Sophos UTM.

But because I'm not a professional I really do find it hard to understand how to operate it correctly. I can read the user manual but without live examples I find it very hard to relate to my (personal) setup.

I have got two WANS and one LAN.  The WANS are slow ADSL connections which is all we can get here.  Auto balancing is enabled.  Off it I am running 10 PCs, a Voip server , 5 Cisco voip handsets, 6 smart phones, 2 laptops, and a partridge in a pear tree.

My troubles are as follows:

Question
I have to configure a multpath rule so VOIP only runs through one of the WANs.  I dont understand "what to put where" in the multipath rules. A bit of advice would be appreciated.   I'm running a VOIP PBX called 3CX on PC 192.168.1.2 and it uses ports 5060(sip) and also 9000:9014 (rtp) to operate, and it has to go down one wan, not both or either.

Pls advise correct parameters for the multipath rule:
SOURCE:?
SERVICE: (I assume the port)?
DESTINATION:?
ADVANCED: BALANCE TO: (assume WAN1)?



Thanks guys -you're the best. [:)]

Cheers
Noddy


This thread was automatically locked due to age.
2013-05-28 21_06_25-Microsoft Excel - wan & QOS config.zip
Parents
  • One other comment to make.  

    I have noticed that (under the current set up with no multipath rules) the auto balance is not really doing its job.

    For example, I know for a fact my connection speed on each WAN is about 5 megabits a second download rate.

    with two applications open  - Vuze (bit torrent) and SABNZBD (Usenet client), it all seems to go through one WAN.  Shouldnt it split Vuze to Wan1 and Sab to Vuze 2 - in order to maximise the download speeds of both wans?
Reply
  • One other comment to make.  

    I have noticed that (under the current set up with no multipath rules) the auto balance is not really doing its job.

    For example, I know for a fact my connection speed on each WAN is about 5 megabits a second download rate.

    with two applications open  - Vuze (bit torrent) and SABNZBD (Usenet client), it all seems to go through one WAN.  Shouldnt it split Vuze to Wan1 and Sab to Vuze 2 - in order to maximise the download speeds of both wans?
Children
No Data