This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

utm 9 - problem with dhcp and serveral networkcards

hello
i am new on this forum an sophos utm.

what i have is a PC with a virtual runnning mashine with sophos utm 9 and the free licencs for 50 IPs. the PC has 3 network cards.

what i want to do is:
connect 1 card to my personal lan which has access to the internet. (router 192.168.2.1)
connect card 2 to another router (192.168.179.1) an connect card 3 to the guest network, traffice on the guest network should go to card 3 trough sophos utm an should be connected to the internet over card 2. on card 3 a DHCP should run.

could this be realized, if yes, what do i have to configure?

This thread was automatically locked due to age.

Parents

0 open over 12 years ago

My english on this special field is not the best, but I try my best to describe.

Fritzbox has a guestmode, so it works on port 1-3 normal and on port 4 like second router for the guestnetwork, so the two subnets are not connected. I am not using the fritzbox wlan, for this I have D-Link access points which are connect to a vlan for the guestnet.

Also UTM should only work in for my guestnet. The network card to my normal network is only for administration ( if it works ).
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 open over 12 years ago

My english on this special field is not the best, but I try my best to describe.

Fritzbox has a guestmode, so it works on port 1-3 normal and on port 4 like second router for the guestnetwork, so the two subnets are not connected. I am not using the fritzbox wlan, for this I have D-Link access points which are connect to a vlan for the guestnet.

Also UTM should only work in for my guestnet. The network card to my normal network is only for administration ( if it works ).
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data