Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DHCP lease Table

How can I clean the DHCP lease table? It is showing some ip should return to the pull but are not. Some of the leases should have expired like 3 days ago but are still in the table. Any ideas why this could be also it shows unknown next to those addresses.


This thread was automatically locked due to age.
  • Michael, your answer is in your signature line! [;)]

    Cheers - Bob
  • Have done it but the most oldest ones did clear up. Does it take 7 days I have seen somewhere else they will drop off after 7days is this true?
  • Non est verum!

    Don't confuse the IP count with the lease time.

    Cheers - Bob
  • Some are still showing up and the machine has been off for a few days. When does the astaro clean up dhcp leases. I have changed it form default to two hours hoping this would clean the table still no go.
  • Hi, 

    I would say that looking at the dhcpd config file should answer your question,
    On version 8.5, it's at
    /var/chroot-dhcps/etc/dhcpd.conf

    Mine shows:
    # Lease times
    # 600s = 10m
    # 14400s = 4h
    # 86400 = 1d
    # 172800 = 2d
    max-lease-time 172800;
    default-lease-time 86400;
    min-lease-time 600;


    But that means they should expire after a max of 2 days.

    There must be another parameter somewhere, but I don't know where.

    I found
    "New leases are appended to the end of the dhcpd.leases file. From time to time, dhcpd removes obsolete information to prevent the file becoming too large. "
    at /var/state/dhcp/dhcpd.leases
    but that isn't very specific.

    Note that it can be GOOD that the lease information is kept, that way a device that is only online once in a while would still tend to have the same IP.

    I would guess that as the pool gets full, dhcpd would be more likely to do a 'clean-up'... are you having trouble running out of IPs in your dhcp scope?

    Barry