Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 6 replies
  • Answers 1 answer
  • Subscribers 4 subscribers
  • Views 9158 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Getting Link error when check Uplink Balancing

irfan
Hi 

Please look into my scenario and post the solution if any one know.

I have 2 Uplinks for ex L1 and L2 

L1 is connected to Interface eth1 and L2 on eth2
and eth0 is reserved for Internal network (LAN)

I wanted to make both link work with load balacing criteria 
I made all the possible settings related to Uplink and rule creation ,even though i facing proble that one link showing Interface as Up and Link as error
.
Please help me to come out of this.


This thread was automatically locked due to age.
Parents
  • 0

    Hi guys,

    Same problem here. Im running Sophos UTM 9, firmware 9.408-4.

    If i enable Uplink Balancing, one of my interfaces turn to ERROR (state=UP, link=ERROR). If i disable Uplink Balancing, the interface turn to UP again.

    I've tryied to change some settings on Uplink Balancing, but any of them could fix the problem.

    Any ideias?

Reply
  • 0

    Hi guys,

    Same problem here. Im running Sophos UTM 9, firmware 9.408-4.

    If i enable Uplink Balancing, one of my interfaces turn to ERROR (state=UP, link=ERROR). If i disable Uplink Balancing, the interface turn to UP again.

    I've tryied to change some settings on Uplink Balancing, but any of them could fix the problem.

    Any ideias?

Children