Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 11 replies
  • Subscribers 2 subscribers
  • Views 1784 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG220 8.306 - Bridging and Vlans Issue

Stum
ASG220 sits between internal network and cisco pix.

Eth0 and 1 Bridged, users are pulled from AD, Webfiltering and profiles are configured for Transparent mode with Browser authentication.

When you go to browse you get the browser prompt for login details and the proxy profiles seem to be working fine.
 
Until you change the bridge from standard to Vlan then it all falls apart [:(] users now have full browsing access with no prompt for details.

Pulling my hair out (whats left of it) , where am i going wrong ?

Regards
Stu


This thread was automatically locked due to age.
Parents
  • 0
    I think you've discovered the problem with transparent on the bridge - good job of creative problem solving!  I've not run into that bug before.  I don't think there's any point in using tcpdump.

    You might want to revisit the decision about AD.  Check out Configuring HTTP/S Proxy Access with AD-SSO. 

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0
    I think you've discovered the problem with transparent on the bridge - good job of creative problem solving!  I've not run into that bug before.  I don't think there's any point in using tcpdump.

    You might want to revisit the decision about AD.  Check out Configuring HTTP/S Proxy Access with AD-SSO. 

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data
Cookie Information Banner