Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Uplink balancing all traffic to primary int if down all traffic to secondary int

Hi have some question

Running astaro version 9 latest update
need to setup uplink load balancing, my scenario is 1 isp with copperline 10mb connection connected to eth1.
1 3/4G connected to dovado tiny in bridge mode(because astaro has no support for the usb dongel ZTE MF880)connected to eth2 as cable modem
both line has static public ip
I want to use the copper line as primary for all traffic(surf, smtp ..) and if that goes down, the 3/4G line should take over all traffic.
can I set copperline weight to 100 and the 3/4G to 0 and put the copperline as first interface and 3/4G as second interface.
Do i need to use multipath rules for this scenario.
Persistense settings, what should it be in this scenario, default one our
I do not use mail proxy, I use dnat for smtp, https ..

Regards
Rob


This thread was automatically locked due to age.
Parents
  • Hi Barry and Bob
    Thanks for your reply

    I'm having trouble getting this to work, the problem is when it switch to the 3G line outbound traffic works ok.
    The problems is inbound traffic, the inbound traffic reach the firewall, I can see that in FW log but the answer newer goes back.
    This installation is done in my lab fw with utm version 9.
    Today I setup an another fw and started with version 8.102 did the same setup, working ok
    then upggrade to 8.306, ok, backup the config, reinstall with version 9 and put the config back, working ok, upgrade to latet version of 9, still working ok.
    So if starting with clean installation of vsersion 9 and if this is a new installation and not having an backup from version 8 it will not work.
    I have contact the support and the are looking at the problem.

    Barry, why I'm using cable modem is for my isp called my ip for static public ip when I purchased the subscription, but it is a reserved dhcp address.

    Rob
Reply
  • Hi Barry and Bob
    Thanks for your reply

    I'm having trouble getting this to work, the problem is when it switch to the 3G line outbound traffic works ok.
    The problems is inbound traffic, the inbound traffic reach the firewall, I can see that in FW log but the answer newer goes back.
    This installation is done in my lab fw with utm version 9.
    Today I setup an another fw and started with version 8.102 did the same setup, working ok
    then upggrade to 8.306, ok, backup the config, reinstall with version 9 and put the config back, working ok, upgrade to latet version of 9, still working ok.
    So if starting with clean installation of vsersion 9 and if this is a new installation and not having an backup from version 8 it will not work.
    I have contact the support and the are looking at the problem.

    Barry, why I'm using cable modem is for my isp called my ip for static public ip when I purchased the subscription, but it is a reserved dhcp address.

    Rob
Children
No Data