Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Uplink balancing all traffic to primary int if down all traffic to secondary int

Hi have some question

Running astaro version 9 latest update
need to setup uplink load balancing, my scenario is 1 isp with copperline 10mb connection connected to eth1.
1 3/4G connected to dovado tiny in bridge mode(because astaro has no support for the usb dongel ZTE MF880)connected to eth2 as cable modem
both line has static public ip
I want to use the copper line as primary for all traffic(surf, smtp ..) and if that goes down, the 3/4G line should take over all traffic.
can I set copperline weight to 100 and the 3/4G to 0 and put the copperline as first interface and 3/4G as second interface.
Do i need to use multipath rules for this scenario.
Persistense settings, what should it be in this scenario, default one our
I do not use mail proxy, I use dnat for smtp, https ..

Regards
Rob


This thread was automatically locked due to age.
Parents
  • Hi, Rob, and welcome to posting in the User BB!

    Are you getting connection with the 3G USB?  Did you try plugging it in, restarting the UTM and then creating an ionterface of type 3G/UMTS?  If you did or you otherwise know that won't work, then I'm surprised you would have used "Cable modem (DHCP)" rather than "Ethernet standard" to connect it through the Dovado.

    Instead of having the wireless WAN connection in 'Active interfaces', have you tried with it in 'Standby interfaces'?  Then, you don't need to configure multipath rules or even worry about the weighting.

    To understand the trade-offs, you might want to check out Alvin's comment and da_merlin's immediately after Alvin's.

    Cheers - Bob
Reply
  • Hi, Rob, and welcome to posting in the User BB!

    Are you getting connection with the 3G USB?  Did you try plugging it in, restarting the UTM and then creating an ionterface of type 3G/UMTS?  If you did or you otherwise know that won't work, then I'm surprised you would have used "Cable modem (DHCP)" rather than "Ethernet standard" to connect it through the Dovado.

    Instead of having the wireless WAN connection in 'Active interfaces', have you tried with it in 'Standby interfaces'?  Then, you don't need to configure multipath rules or even worry about the weighting.

    To understand the trade-offs, you might want to check out Alvin's comment and da_merlin's immediately after Alvin's.

    Cheers - Bob
Children
No Data