This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Gateway Policy routing - field values

Hi,
when using gateway policy routing, what value goes in the gateway field. The UTM (v9b) doesn't like to use the UTM gateway as defined in the interfaces. So is the value supposed to the other end of the IPS/network providers link? If this is a dynamic value how do you configure it, or do you just choose a value from the ISP/network provider. With IPv6 it is a constant but with IPv4 it changes when using ADSL.

Ian

This thread was automatically locked due to age.

Parents

0 BAlfson over 13 years ago

Ian, did you resolve this already? Doesn't this update automatically in the interface definition? Can't you just use an Interface Route instead?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 13 years ago

Ian, did you resolve this already? Doesn't this update automatically in the interface definition? Can't you just use an Interface Route instead?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 RFCat_vk_01 over 13 years ago in reply to BAlfson

Hi Bob,
no, I didn't resolve it. I was trying lots of different ideas in an attempt to get something to work that is not yet a function of the UTM. I believe the feature will be part of v9.1xx.
It is a failing on my part to understand how IPv6 addresses are deployed by some ISPs.

Ian
Cancel
Vote Up 0 Vote Down

Cancel