This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Clustering question

I have three ASG 425's clustered running 8.203. That will be connected to three different core switches. The ports on the Cisco switches are 10/100/1000, the eth3 ports on the 425's are 10/100/1000.

My question is this.... can I utilize the 1000mb speed of the ports or do I need to back the Cisco core switch ports down to 100mb?

This thread was automatically locked due to age.

Parents

0 William Warren over 13 years ago

not necessarily. Jumbos are a good thing but i've gotten more than 90% using standard frames. It depends on your hardware.
Cancel
Vote Up 0 Vote Down

Cancel
0 James Shakour over 13 years ago in reply to William Warren

not necessarily. Jumbos are a good thing but i've gotten more than 90% using standard frames. It depends on your hardware.

What hardware are you using?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 James Shakour over 13 years ago in reply to William Warren

not necessarily. Jumbos are a good thing but i've gotten more than 90% using standard frames. It depends on your hardware.

What hardware are you using?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data