This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Change External Interface

I have inherited an Astaro ASG625. I don't have a whole lot of experience with Astaro products. When it was configured, they put the the LAN and WAN on the same interface (ETH0) - Please don't ask why. The interfaces were tagged with seperate VLAN's.

I would like to change the external interface to use the WAN port. This firewall has a ton of NAT rules and port forwarding rules. Can someone tell me the best way to go about changing this? I haven't tried changing it yet, but if I just change it, will all these rules be automatically updated?

Thanks

Matt

This thread was automatically locked due to age.

Parents

0 defore6 over 13 years ago

I would like to keep all the settings. There are quite a few NAT rules and a ton of url's in the block and allow lists, as well as some complex E-Mail settings.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 defore6 over 13 years ago

I would like to keep all the settings. There are quite a few NAT rules and a ton of url's in the block and allow lists, as well as some complex E-Mail settings.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data