This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Enabling Bridge

When i tried to enable bridge it returns this error, i can click ok but it won't enable, any ideas? I'm guessing its becasue i don't have enough interfaces available. I was planning to bridge my wan with my modem/router to eliminate double NAT or have i got completely the wrong end of the stick and going about this back to front.

Can't use string ("0") as a HASH ref while "strict refs" in use at /wfe/asg/modules/asg_interfaces.pm line 914.

V8.102 Software
2 Lan (1 WAN and 1 Lan)
Home user license

Thanks in advance.

This thread was automatically locked due to age.

Parents

0 BarryG over 14 years ago

Hi, you'd be much better off bridging the modem instead of the firewall.

However, you should be able to bridge WAN to LAN on the firewall.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 14 years ago

Hi, you'd be much better off bridging the modem instead of the firewall.

However, you should be able to bridge WAN to LAN on the firewall.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Fawlty_01 over 14 years ago in reply to BarryG

Thanks for the reply Barry.

Sorry to ask such a simple question but i couldn't find the answer elseware. If i set bridge mode (instead of route) in the adsl modem do i need to set my WAN interface to adsl or should i leave it as DHCP and it will then get the public IP from the modem.

Cheers
Cancel
Vote Up 0 Vote Down

Cancel