This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Dashboard: IN/OUT bar question

I don't undersand why my IN / OUT bar (the bandwidth bar) are opposite for my eth0 (Cable modem) and eth1(Internal network).

Basically if Cable modem IN = 100 and OUT = 200
the Internal network IN = 200 and OUT = 100.

Which one is the real ME->Internet (OUT) and Internet -> ME (IN).

Why are they opposite?

Thanks!

This thread was automatically locked due to age.

0 BrucekConvergent over 14 years ago

They are not opposite; they are correctly showing traffic. Think of it in terms of traffic flow to / from the individual interfaces on the Astaro.
Cancel
Vote Up 0 Vote Down

Cancel
0 x-cimo over 14 years ago in reply to BrucekConvergent

Well, while downloading something WAN show IN at 10Mbps, which make sense to me, but Internal show OUT at 10Mbps, that dosen't make sense to me? as its comming inside the Internal network?
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 14 years ago

It's 10Mb coming into the External interface, and 10Mb leaving the Internal interface.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 x-cimo over 14 years ago in reply to BAlfson

ha... right... like leaving the internal to get inside the network..

Thanks
Cancel
Vote Up 0 Vote Down

Cancel