Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 230 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

interface issues

computerkiller
I just got a astaro 220 gateway with version 8.02 on it ive configure the device with 192.168.1.1/24 address with DHCP and Ive configure eth1 as wan for internet service to come into it I cant figure out how to make eth4-7 give out DHCP address or just act like a switch i get a DHCP address from eth0 and that is it i do not get anything from eth2-7 but they do light up and are detected


This thread was automatically locked due to age.
  • 0
    Welcome to the User BB!

    The Astaro doesn't have a switch mode - in fact, you will have problems if you try to connect two interfaces to the same physical Ethernet segment.  In any case, the default action for a firewall is to block traffic, so, unless you configure an interface and explicitly allow packets to pass in/out, nothing will happen.

    Cheers - Bob