Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 749 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DynDNS not updating with failover / failback event

LewisRosenthal
Greetings, all...

ASL 7.507

I have two public interfaces, one on static DSL and the other on CLEAR WiMAX (NATted DHCP). I'm using DynDNS custom. During testing, I failed out my primary (DSL) connection, and waited for the backup (WiMAX) to go active. The interface came up within 17 seconds. Unfortunately, the DynDNS updater...didn't. I waited about 20 minutes for DynDNS to update before manually logging in via the web to update the IP.

Likewise, failing back yielded similar results (i.e., no DynDNS update).

Besides configuring uplink monitoring & the DynDNS account info, is there anything I'm missing to trigger an update event when the interface fails over?

TIA


This thread was automatically locked due to age.
Parents
  • 0
    Same issue with 7.509, BTW.

    DSL is atrocious, which prompted a manual failover (i.e., flipped the power switch on the DSL bridge). WiMAX came right up, but four hours later, no DynDNS update (until I just did it manually).
Reply
  • 0
    Same issue with 7.509, BTW.

    DSL is atrocious, which prompted a manual failover (i.e., flipped the power switch on the DSL bridge). WiMAX came right up, but four hours later, no DynDNS update (until I just did it manually).
Children
No Data