Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

External interface connecting at 10MBPS

My external interface is only connecting at 10 MBPS and I'm wondering if this is where my bottleneck is coming from.  On the firewall itself, the orange 10 Mbps light is on, and that's it.  

My cisco router from Qwest is configured for 100 mbps/Full duplex.  Is there a way I can change/fix this issue?

Thanks


This thread was automatically locked due to age.
Parents
  • I'm not familiar with the ASG 220 hardware, but that ethtool output suggests that that is a Gigabit NIC.  In my experience, NIC speed LEDs usually show green only at their highest speed, meaning that it would be off for both 10 and 100 Mbit connections.

    Or perhaps yours has just decided to indicate the chance of rain instead! [:)]

    But whatever the case, I'm glad you're getting the 100Mbit connection you expected.

  • Or perhaps yours has just decided to indicate the chance of rain instead! [[[:)]]]


    [:D] ahahahah, this second solution is the right one [[[:)]]]


    But whatever the case, I'm glad you're getting the 100Mbit connection you expected.


    Anyway the strangeness is that I have 5 ethernet card used on my ASG, and eht0 is the only with this issue.... bah! [[[:)]]]
Reply

  • Or perhaps yours has just decided to indicate the chance of rain instead! [[[:)]]]


    [:D] ahahahah, this second solution is the right one [[[:)]]]


    But whatever the case, I'm glad you're getting the 100Mbit connection you expected.


    Anyway the strangeness is that I have 5 ethernet card used on my ASG, and eht0 is the only with this issue.... bah! [[[:)]]]
Children
No Data