Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

External interface connecting at 10MBPS

My external interface is only connecting at 10 MBPS and I'm wondering if this is where my bottleneck is coming from.  On the firewall itself, the orange 10 Mbps light is on, and that's it.  

My cisco router from Qwest is configured for 100 mbps/Full duplex.  Is there a way I can change/fix this issue?

Thanks


This thread was automatically locked due to age.
Parents
  • Hi, you can set the speeds manually via webadmin under the interface settings.

    As long as the switch supports 100baseT I don't see why you'd get any errors, but you can run ifconfig to see if there are any interface errors.
    Also run it before the change so you can subtract any old errors.

    Barry
  • Hi, you can set the speeds manually via webadmin under the interface settings.

    As long as the switch supports 100baseT I don't see why you'd get any errors, but you can run ifconfig to see if there are any interface errors.
    Also run it before the change so you can subtract any old errors.

    Barry


    Barry, I have set 100baseT, but the green led is always turned off for eht0 (the other ports have green led turned on with auto negotiation). 

    Is it normal?
Reply
  • Hi, you can set the speeds manually via webadmin under the interface settings.

    As long as the switch supports 100baseT I don't see why you'd get any errors, but you can run ifconfig to see if there are any interface errors.
    Also run it before the change so you can subtract any old errors.

    Barry


    Barry, I have set 100baseT, but the green led is always turned off for eht0 (the other ports have green led turned on with auto negotiation). 

    Is it normal?
Children
No Data