Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

External interface connecting at 10MBPS

My external interface is only connecting at 10 MBPS and I'm wondering if this is where my bottleneck is coming from.  On the firewall itself, the orange 10 Mbps light is on, and that's it.  

My cisco router from Qwest is configured for 100 mbps/Full duplex.  Is there a way I can change/fix this issue?

Thanks


This thread was automatically locked due to age.
Parents
  • When I go into the cisco router and do a sh interface I get this for the external port


    Full-duplex, 100Mb/s, 100BaseTX/FX

    Maybe I'm looking at the wrong thing.  I'm just confused as hell right now.
  • Some Cisco gear does not autonegotiate well, so you will need to manually set the interface speeds on both the Cisco and the Astaro (try just the ASG first).  You could also put a dumb switch between the ASG and the Cisco, that may help.  Note- this is not Astaro specific, I have had this issue with Cisco gear connected to a variety of devices through the years.
  • So, what I am trying to figure out is if this is the reason we are getting slow speeds externally.  

    We have a web based software package that people connect to outside of the network.  We have anywhere from 10-50 users on at a give time.  They are complaining of slow speeds.  I noticed that our firewall was only connected at 10mbps, so am I correct in thinking this could be the cause of the problems?
  • In theory, is shouldn't be a problem unless you have greater than 10mbps of Internet bandwidth- but in reality, it probably means the interface is losing a lot of traffic and so it is probably the problem.

    Do an ifconfig (e.g. "ifconfig eth2") on the problem interface and look at the errors, wait a minute or so and do it again- see if they've climbed.
  • sorry for being such a noob, but I couldn't get ifconfig eth1 or eth0/1 to give me anything.......

    But I did see this on the interface

    Half-duplex, 100Mb/s, 100BaseTX/FX.....Is this any cause for concern?  Should it be full duplex?

    The other interface (router to internet) shows full duplex etc.
Reply
  • sorry for being such a noob, but I couldn't get ifconfig eth1 or eth0/1 to give me anything.......

    But I did see this on the interface

    Half-duplex, 100Mb/s, 100BaseTX/FX.....Is this any cause for concern?  Should it be full duplex?

    The other interface (router to internet) shows full duplex etc.
Children
No Data