Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to add a connection that issues DHCP

Hi,

I am using a ASG 220 and currently have our main Internet connection configured.

I have been asked to connect to another service which is being presented to me as a standard RJ45 connection.  However this is connected to its own CISCO router which is DHCP enabled.

My question is how can I connect this to the ASG so that it uses the IP address from the CISCO router?  I can manually asign the ASG a static IP address, however the CISCO's IP range may be changed from time to time and this could cause a disconnect (and typically it will happen at some time in the future once we have forgotten we asigned a static IP).

Many thank in advance.

David


This thread was automatically locked due to age.
  • Just configure the interface to the Cisco device as a ""Cable modem", that really just means the interface is a DHCP client.  Just make sure you don't set it as a default gateway, and that there aren't any address space overlaps.
  • JD,

    Thanks for your reply.  Unfortunately I cannot access or change the CISCO at all [:(]

    I tried to plug it into a spare port on the ASTARO and configure it as Cable Modem (DHCP), though this did not work.

    Many thanks.

    David
  • Maybe I misunderstood- does the Cisco issue DHCP?  Or something else on that segment?  If so, the cable modem setting should work.  If there is no DHCP available for that interface on the Astaro, you will have to use a static IP address.

    Do you get link?  If not, you may need to use a crossover cable, or possibly set the link state and speed manually on the interface connected to the Cisco.
  • JD,

    It is indeed the Cisco that gives out the DHCP requests.  I can set up a manual IP, however I am lead to believe that the DHCP range may change on the Cisco (never heard of it myself, but thats what I am being told).

    The link us [up] but the status is [down].  I will try a cross over cable just in case.

    Many thanks.

    David
  • Hi,

    I removed all the settings and added them all back it, now it seems to work - very odd.  Perhaps I did something different this time around.

    Either way, thanks JD for your help.

    David