Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problems with Meshed Cluster Setup

Hello,

I am trying to setup a Meshed Cluster Setup as described in the Astaro Cluster Deployment Guide on page 13. As long as all cables are patched everything is working fine.

Now I want to simulate what happens if a cable or device fails. As long as I remove one cable only from one Astaro to one internal switch everything is working as described. But in the case one internal switch fails, the hole link aggregation group on all Astaros go down. All Astaros switch to state 'unlinked' and now traffic is processed.

Can anybody please give me an advice what I did wrong?

Thank you in advance,
Stephan


This thread was automatically locked due to age.
Parents
  • Finally I solved the problem.

    I removed the slave device from the cluster, rebooted the master, added the slave again and configured everything new. Then I rebooted the hole system again.

    Now everything works fine. The log shows the right messages and a maximum of 3 or 4 pings get lost until the connection is back up again.

    It's like a dream come true. [:D]

    Thank you very much for your assistance.
Reply
  • Finally I solved the problem.

    I removed the slave device from the cluster, rebooted the master, added the slave again and configured everything new. Then I rebooted the hole system again.

    Now everything works fine. The log shows the right messages and a maximum of 3 or 4 pings get lost until the connection is back up again.

    It's like a dream come true. [:D]

    Thank you very much for your assistance.
Children
No Data