This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reset Allowed Networks in WebAdmin

Hey guys, I just installed Astaro today and I gotta say that I'm quite impressed with it so far. The flexibility is great, just what I've been looking for.

Anyways, I was trying to harden the setup by allowing only my IP to access the WebAdmin, but then I switched NICs and IPs and I also forgot to change the Allowed Networks for WebAdmin access. Now it won't let me access the WebAdmin. I even tried plugging my PC to the old NIC and IP, it still won't let me access it, but I can ping 192.168.0.1. The connection just times out everytime I try to access port 4444.

Is there a way to reset the Allowed Networks to "Any" on the console?

This thread was automatically locked due to age.

0 techuser over 15 years ago

did you try to login via ssh?
Cancel
Vote Up 0 Vote Down

Cancel
0 Fixed-Solutions over 15 years ago
as techuser said if you have SSH Access to allow the ip : 192.168.0.10
use this iptables command

iptables -A INPUT -s 192.168.0.10 -p tcp -m tcp --sport 1024:65535 --dport 4444 -j ACCEPT

if you don't have ssh enabled.

i think you have console access or VGA + Keyboard.

so you can access Linux Terminal

execute the above command
Cancel
Vote Up 0 Vote Down

Cancel
0 tmaz42o over 15 years ago

I don't have SSH enabled, but I do have a keyboard and monitor connected. So I will execute that command, I'll let you guys know the outcome in a few minutes.
Cancel
Vote Up 0 Vote Down

Cancel
0 tmaz42o over 15 years ago in reply to tmaz42o

I just re-installed Astaro. I had more problems than I originally thought. Thanks for the suggestions.
Cancel
Vote Up 0 Vote Down

Cancel
0 Fixed-Solutions over 15 years ago

you are welcome
Glad to hear that your problem is gone.
Cancel
Vote Up 0 Vote Down

Cancel