This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[7.501] After Update to 7.501 MultiPath Rules not working

Hi,
I have two Uplink Interfaces (One ADSL and one SDSL).
I enabled Multipath for these two Interfaces.
The SDSL ist the top one on the Uplink-Balancing
Configuration Page in WebAdmin.

For testing purposes I created a Multipath-Rule [by Interface]
Any-Any-Any->ADSL

But all traffic is routed over the SDSL Interface!

Anyone the same problem?

This thread was automatically locked due to age.

Parents

0 Goldy_01 over 15 years ago

Great.

BTW, if you enable "Automatic Monitoring" you don't have to define any "Monitoring Hosts".
In my experience, "Automatic Monitoring" work better.
Cancel
Vote Up 0 Vote Down

Cancel
0 SveN_01 over 15 years ago in reply to Goldy_01

You are correct, if you enable Automatic Monitoring you don't have
to define hosts, but if you disable it, you must define hosts.
A that is what i did not do.....
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 SveN_01 over 15 years ago in reply to Goldy_01

You are correct, if you enable Automatic Monitoring you don't have
to define hosts, but if you disable it, you must define hosts.
A that is what i did not do.....
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data