This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

After update to v7.5 HA isn't working correctly...

Hello there,

i'm using 2 older astaro (pyramid appliances), which are supportes via HCL (NIC etc.).

This constellation is running in Hot-Standby (Active-Passive) HA-Mode and works fine until version 7.403.

Now i've updatedet to version v7.404, v7.405 and finally v7.500.
Both systems restarted but the nodes cannot find each other (please see attachment "HA-Syncfehler nach ..."). [:O]

After i rebooted both devices i get a connect between the nodes an after a few minutes the message appears in Live-Log, that node2 have synced. [:$]

Now i get new warnings (please check attachment "LBeat Fehler nach...") but the system says to me, that HA is working?! [:S]

Thx in advance,

Manuel

This thread was automatically locked due to age.

0 Microsaft over 15 years ago

Please read the notice at up2date.astaro.com !
Not sure but maybe this important for you....
Cancel
Vote Up 0 Vote Down

Cancel
0 ManuelKarl over 15 years ago in reply to Microsaft

Yes, i read a few minutes ago.... but to late. Update was already done.

I think i got the same problem like in https://community.sophos.com/products/unified-threat-management/astaroorg/f/55/t/44235.

Thx,

Manuel
Cancel
Vote Up 0 Vote Down

Cancel