This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Interface has Link as "Error" on Multipath member

I have 3 T1's coming in and have setup Multipath on all 3. Each is a different subnet and are going over Eth7, Eth6 and Eth5.

On the Dashboard, Eth5 shows an Error under Link. and very little traffic is passing over it. I moved it up in the MP priority to see if the traffic increased which it did not. I have it configured EXACTLY as Eth6. Any ideas?

This thread was automatically locked due to age.

0 BAlfson over 16 years ago

Please show pictures of your 'Uplink Balancing' tab and your 'Multipath Rules' tab.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 BramKortleven over 16 years ago in reply to BAlfson

Any idea why it appears with an 'Error' in the link state?
We have a similar situation which needs resolving...

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
0 BramKortleven over 16 years ago

OK, resolved...
Turn of the Automatic Monitoring and put in a couple of servers you think will never go down (or at least at the same time).
Link status 'OK' now.
Make sure to insert, after adding it to the Uplink interfaces, the Default gateway of the second interface and to set it as Default Gateway (which off course doesn't work in a single internet-connection setup).

Works like a charm now!
Cancel
Vote Up 0 Vote Down

Cancel