This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Trixbox/Asterisk packet filter rules

I finally dug this up and wanted to post it here in case someone is digging around for the rules:

1) Use the already included SIP protocol information
2) DEPENDING ON YOUR CONFIGURATION Please check \etc\asterisk\rtp.conf for the port range your setup is configured to use for the Asterisk RTP protocol. Most commonly it is

UDP 1:65535 -> 10000:20000

You may also have to configure your VOIP client to only use that range of ports. Good luck!

This thread was automatically locked due to age.

0 BarryG over 16 years ago

10,000 ports seems excessive for most users; is Trixbox configurable?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 BrucekConvergent over 16 years ago in reply to BarryG

Sure is... just edit the rtp.conf file. We use this system ourselves, pretty slick actually.
Cancel
Vote Up 0 Vote Down

Cancel