Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pass-through interface?

I was hoping the board could help with a configuration I need to set up for a DR site.  We are currently using ASG 7.4 and we need to add an additional VPN router for a service provider at the DR location.  The new VPN router must have an externally accessable public IP and I want to pass this through the ASG box to avoid additional cost from the ISP.  The ASG box has 3 NICs and they are as follows:

NIC 1 - External interface connected to the ISP
NIC 2 - Internal Network
NIC 3 - New interface to connect to the VPN router

Can I configure NIC 3 as a bridge interface to avoid consuming an IP address?  Or will I need to burn an additional public IP on that interface and confiure routing?  

Thank you!


This thread was automatically locked due to age.
Parents
  • They use a hardened router

    Crafty, I guess they think the Astaro is chopped liver. [;)]

    It seems like bridging should work, but I haven't used it much.  If we don't get one of the bridging gurus by here, please post the results of your experiment.

    riedwetter, is this how you solved the problem, or are you asking a question?  If a question, are these two devices already in service with public IPs?

    Cheers - Bob
Reply
  • They use a hardened router

    Crafty, I guess they think the Astaro is chopped liver. [;)]

    It seems like bridging should work, but I haven't used it much.  If we don't get one of the bridging gurus by here, please post the results of your experiment.

    riedwetter, is this how you solved the problem, or are you asking a question?  If a question, are these two devices already in service with public IPs?

    Cheers - Bob
Children