This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to check IPSEC-VPNs by SNMP?

Hello,

I try to get the ASG 7.007 monitored my SNMP. So far works fine but:

If i do a snmpwalk to the Astaro on IPSEC0 this will output sth like this:

RFC1213-MIB::ifOperStatus.7 = INTEGER: up(1)

So IPSEC0 is online. 1-4 is offline.

I have two tunnels online but only IPSEC0 is shown as up.

How can I get both IPSEC tunnels monitored by SNMP?

Thanks...

HuGO

This thread was automatically locked due to age.

Parents

0 MaxwellOliveira over 7 years ago

I would also like to know how to monitor an IPSec tunnel through SNMP.

I see that the IfInOctets registry of the ipsec0 or tunnel interface always gets 0.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 MaxwellOliveira over 7 years ago

I would also like to know how to monitor an IPSec tunnel through SNMP.

I see that the IfInOctets registry of the ipsec0 or tunnel interface always gets 0.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 BAlfson over 7 years ago in reply to MaxwellOliveira

Olá Maxwell,

On the 'Notifications' tab of 'Management - Notifications', you can see that there are only very few SNMP messages available. Do you see there what you wanted? If not, please share your concern.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel