Uplink Balancing don't release the line properly

Only new connections are build using the recreated  primary line after the 5 Minutes timeout.

Existing connections are not disconnected...

Thanks.
That's not the situation here.
Some of the workstations kept going thru the alternative line after closing the brouser and even after restart the workstation.
Normaly the alternative line should die out after a short time.
In this case  the UTM kept sending some users to the alternative line,long after the main WAN start working.

Thanks.
That's not the situation here.
Some of the workstations kept going thru the alternative line after closing the brouser and even after restart the workstation.
Normaly the alternative line should die out after a short time.
In this case  the UTM kept sending some users to the alternative line,long after the main WAN start working.

Shalom Goldy,

I prefer to use Multipath Rules instead of weighting.  The bonus is that the MP rules are clear and obvious - self-documenting.  They are processed in order and subsequent rules are not considered.  For example:

1. Bind Any->Any->Any to fastest
2. Bind Any->Any->Any to next-fastest
3. Bind Any->Any->Any to slowest

Do you still see the same phenomenon after switching from weighting to Multipath Rules?

Cheers - Bob

Hi Bob.

From experience, when the "Fastest line" go back to work, how long it would it take it, so all connections will drop from the second line.

Thanks...

as far as I could see ... not within 12 hours.
existing connections (SIP-TRUNC) stay connected ... at the backup-line.

@Bob. this occurs with Multipath too.

Right, Dirk - my fault for not reading closely enough!

Cheers - Bob