Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 6 subscribers
  • Views 11469 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Configure HA. Not monitoring eth3?

JSinclair

I recently had to unconfigure HA between two SG 430s because of an issue with postgresql. I am now trying to reconfigure HA but I'm not getting link lights when I connect the cables. The cables are connected to eth3, but the live log says it's "Monitoring interfaces for link beat: eth1". I tried disabling link monitoring on eth1, but got "Found no interfaces in /etc/ha/lbeat_interfaces for link beat monitoring". I had rebooted the Slave UTM and briefly saw link lights with the log "Netlink: Found link beat on eth3 again!", but the immediately went off and "Netlink: Lost link beat on eth3!" was logged. 



This thread was automatically locked due to age.
Parents
  • 0
    The flexi port modules are not activated by default like the "onboard" ports.
    Factory reset does not activate them.

    I found 2 ways to solve:
    1. Import a backup of the HA master before booting
    2. log in to the default 102.168.0.1, do a minimal setup, activate eth3 and reboot.
Reply
  • 0
    The flexi port modules are not activated by default like the "onboard" ports.
    Factory reset does not activate them.

    I found 2 ways to solve:
    1. Import a backup of the HA master before booting
    2. log in to the default 102.168.0.1, do a minimal setup, activate eth3 and reboot.
Children
No Data
Unfiltered HTML