Guest User!

You are not Sophos Staff.

Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 4 subscribers
  • Views 2543 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reboot cannot be proceeded after initializing SG230 by SUSI

TomojiNamiki

Dear all,

I have faced this issue today.

I was asked to reboot the UTM 9.3 after SUSI installation, and I did it by selecting Reboot menu in the LCD monitor.

But the unit does not reboot while showing INIT: no more processes left in this runlevel in the VGA monitor.

So I did power-off the switch to force shutdown.

Is this a proper way for rebooting the UTM or any problem wit the hardware?



This thread was automatically locked due to age.
Parents
  • 0
    You should have used a keyboard connected during the install. The front panel LCD menu wouldn't be fully functional until after the post-install reboot. A hard shutdown isn't optimal, but in the case of reboot just after install, it isn't going to hurt anything.
Reply
  • 0
    You should have used a keyboard connected during the install. The front panel LCD menu wouldn't be fully functional until after the post-install reboot. A hard shutdown isn't optimal, but in the case of reboot just after install, it isn't going to hurt anything.
Children