This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Getting it all on the UTM

I am new to UTMs. I currently have my ISP modem (Comcast) connected to my Asus RT-AC66R router at the WAN port. My UTM has a dual NIC with eth0 as LAN and eth1 as WAN. Eth0 is connected to my main computer (MB has dual NIC, other NIC on MB is connected to Asus router) so I can access the UTM, eth1 to a port on the router for Internet access.

I can change the router from Wireless Router mode to Access Point mode which should turn DHCP and NAT off on the router. UTM software was installed as 32 bit.
I'm not quite sure how to connect everything so I can manage the UTM and still have both wired and wireless connections through the Asus router. Ok....stop laughing, I said I was new to all of this.

Any help is greatly appreciated!

This thread was automatically locked due to age.

0 Scott_Klassen over 9 years ago

See https://community.sophos.com/products/unified-threat-management/astaroorg/f/51/t/21968.

If you have further questions on this topic, please post back to here.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 MichaelLilley over 9 years ago

Ok, so I have purchased a Sophos AP55C. How do I configure my UTM so I can use it as my router (taking my current router out of service), connected to the switch (with PoE for the AP) and Internet shared through the switch to my wired devices as well?
Cancel
Vote Up 0 Vote Down

Cancel