This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SG125W UTM shows incorrect SSD Size after re-imaged

Hi, i've just re-imaged the SG 125W Hardware appliance after few failed attempts but got there in the end. After the install has been completed, the Data disk and log disk sizes are shown as incorrect.

SG 125W Hardware appliance has 320GB SSD built-in. So, i'd assume to see the relevant size disks but they are showing as below.

Log Disk 24.9GB

Data Disk 18.9GB

Any ideas to re-claim the drive space would be very much appreciated.
Cheers.

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

That's odd. Are you certain that you used the Hardware install image (name starts with SSI) and not the Software (name starts with ASG)? Did you install from CD via USB? What version of the ISO?

If you login to the shell (as loginuser, then su to root), what do you get if your run lsblk?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 OmerAhmed over 9 years ago in reply to Scott_Klassen

Hi Scott, thank you for your quick reply, yes I've used the hardware install image "ssi-9.312-8.1.iso" downloaded from sophos website. Installed the image from boot-able USB following instructions from link below.

Fastvue Sophos Reporter Creating Your Own Sophos UTM Bootable USB Installation Drive

lsblk shows the output below.

NAME   MAJ:MIN RM   SIZE RO MOUNTPOINT
sda      8:0    0  59.6G  0
├─sda1   8:1    0   350M  0 /boot
├─sda2   8:2    0     4G  0 [SWAP]
├─sda3   8:3    0     1G  0
├─sda4   8:4    0     1K  0
├─sda5   8:5    0  20.3G  0 /var/storage
├─sda6   8:6    0   5.4G  0 /
├─sda7   8:7    0  26.7G  0 /var/log
└─sda8   8:8    0   1.4G  0 /tmp
Cancel
Vote Up 0 Vote Down

Cancel
0 Etienne_Liebetrau over 9 years ago in reply to OmerAhmed

Hi all

The procedure set out in Fastvue Sophos Reporter Creating Your Own Sophos UTM Bootable USB Installation Drive is not supported, as such the article has been updated to reflect this.

It can be a handy work around if you are stuck without the required hardware but it is a work around, not a supported method.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Etienne_Liebetrau over 9 years ago in reply to OmerAhmed

Hi all

The procedure set out in Fastvue Sophos Reporter Creating Your Own Sophos UTM Bootable USB Installation Drive is not supported, as such the article has been updated to reflect this.

It can be a handy work around if you are stuck without the required hardware but it is a work around, not a supported method.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data