This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SG125W UTM shows incorrect SSD Size after re-imaged

Hi, i've just re-imaged the SG 125W Hardware appliance after few failed attempts but got there in the end. After the install has been completed, the Data disk and log disk sizes are shown as incorrect.

SG 125W Hardware appliance has 320GB SSD built-in. So, i'd assume to see the relevant size disks but they are showing as below.

Log Disk 24.9GB

Data Disk 18.9GB

Any ideas to re-claim the drive space would be very much appreciated.
Cheers.

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

Installed the image from boot-able USB following instructions from link below
Completely unsupported, so it's very possible that there's an issue with it. I would suggest that you install the correct/supported way and see if it resolves your issue.

Burn to CD using low speed, then connect a CD/DVD via USB (either native or using an IDE/SATA to USB adapter) and install that way.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 OmerAhmed over 9 years ago in reply to Scott_Klassen

i'll try to re-image it using the USB DVD drive and will post the outcome.

Thank you.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 OmerAhmed over 9 years ago in reply to Scott_Klassen

i'll try to re-image it using the USB DVD drive and will post the outcome.

Thank you.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data