Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I need some advices about hardware

Hello,

As I work as a network and system engineer, I've installed a Sophos UTM at home, running on an old computer :

Atom D510 with 2 network cards ( one on the motherboard, a Realtek) and an additionnal PCI Intel Network card. 

I have a 25 Mbps/1Mbps VDSL connection. 

The motherboard seems to have reliability problems, so I'm planning to change the hardware and I would like to buy hardware that will last and be able to handle an increased load : I think that in the next 2 years, I'll have a Fiber 500 Mbps/200 Mbps connection. 

I have selected this hardware :

1 x SuperMicro A1SAi-2750F mother board
2 x Kingston ValueRAM SO-DIMM 8 Go DDR3L 1333 MHz ECC CL9 
1 x Akasa Galileo case
1 x Kingston SSDNow V300 Series 120 Go for storage

I don't really care if I'm stuck at 100 Mbps per connection, but there is about 30 network devices in my house.

What do you think of this hardware ? The key feature here is that it is absolutely noise less and that is a key component here for me.


This thread was automatically locked due to age.
Parents
  • Ok, I've received the parts, get them assembled and reinstalled the UTM. 

    I did yesterday evening a quick check of the throughput I can get throught the UTM, and I'm getting 512 Mbps with IPS on. All the IPS attack patterns are checked. Advanced Threat Prevention is ON too.

    I will post a full bench report as soon as I make one. 

    I'm not sure that my settings are good because the throughput is surprisingly high for a Celeron N2930.
Reply
  • Ok, I've received the parts, get them assembled and reinstalled the UTM. 

    I did yesterday evening a quick check of the throughput I can get throught the UTM, and I'm getting 512 Mbps with IPS on. All the IPS attack patterns are checked. Advanced Threat Prevention is ON too.

    I will post a full bench report as soon as I make one. 

    I'm not sure that my settings are good because the throughput is surprisingly high for a Celeron N2930.
Children
  • Hi,
    I had 3 seperate hardware devices all idling around 30w. I looked at the hardware and decided with extra ram the 2012 small office server could become a VM to see what it idled at. Ended up needing extra NICs as well.

    With a UTM, SUM and small 2012 home server the combination idles at 52w which is a reasonable saving. Electricity in Australia is not cheap.

    Ian M[:)]
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?