Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 2 subscribers
  • Views 796 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

re-labeling the eth interfaces after install

whitetr6
I have a UTM 120 that I reinstalled with the software appliance iso so I could use it at home with my home use license. Now that it's installed, I found that the interfaces are reversed from how they are labeled on the case. Local network is eth0 in the web admin, but the actual interface is the one on the far right, labeled on the case as eth3.

Is there a way to change the interfaces so they match how they're labeled on the case?

Thanks


This thread was automatically locked due to age.
Parents
  • 0
    Edit an interface.  You can now re-assign it to a different NIC port using the Hardware option.  Be aware that you cannot change an interface that you are currently connected through, so to get them all, you'll need to connect a couple of different times via two different interfaces.
Reply
  • 0
    Edit an interface.  You can now re-assign it to a different NIC port using the Hardware option.  Be aware that you cannot change an interface that you are currently connected through, so to get them all, you'll need to connect a couple of different times via two different interfaces.
Children
No Data