This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Install with active trunk VLAN port

Hi,
I'm trying to install the 9.308016 appliance onto a server. I have 4 x 10Gb ethernet NICs and one OOB IPMI interface (SuperMicro hardware).

Default installation works fine, and I have chosen Eth1 as my webadmin interface, but once setup is completed I am unable to reach the :4444.

The problem is that the network switch I am connected to is already configured as a VLAN Trunk with 933,935 permitted. My admin IP is on the 933 vlan.

I dont have access to the network switch so am unable to get the network side reconfigured to remove the trunk configuration.

My question is, how can I configure (from the console) my eth1 interface to enable the vlans, so I can then login to the webadmin and complete setup.

Does anyone have any bright ideas?

Thanks,

This thread was automatically locked due to age.

Parents

0 BAlfson over 10 years ago

Copy that entire line, only changing the vlantag to what you have instead of 1.

If it doesn't work, you can check for the correct name of the interface:
cc
interfaces
interfaces@
quit

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 10 years ago

Copy that entire line, only changing the vlantag to what you have instead of 1.

If it doesn't work, you can check for the correct name of the interface:
cc
interfaces
interfaces@
quit

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Install with active trunk VLAN port

Submitted a Tech Support Case lately from the Support Portal?