This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Install with active trunk VLAN port

Hi,
I'm trying to install the 9.308016 appliance onto a server. I have 4 x 10Gb ethernet NICs and one OOB IPMI interface (SuperMicro hardware).

Default installation works fine, and I have chosen Eth1 as my webadmin interface, but once setup is completed I am unable to reach the :4444.

The problem is that the network switch I am connected to is already configured as a VLAN Trunk with 933,935 permitted. My admin IP is on the 933 vlan.

I dont have access to the network switch so am unable to get the network side reconfigured to remove the trunk configuration.

My question is, how can I configure (from the console) my eth1 interface to enable the vlans, so I can then login to the webadmin and complete setup.

Does anyone have any bright ideas?

Thanks,

This thread was automatically locked due to age.

Parents

0 BarryG over 10 years ago

See the first post on page 4:
https://community.sophos.com/products/unified-threat-management/astaroorg/f/51/t/21326

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 briank5400 over 10 years ago in reply to BarryG

Hi, I saw that one but Im struggling with the syntax. I've tried to copy word for word but I get Syntax error.. (see attach)
[:S]
- Capture.jpg
- View
- Hide
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 briank5400 over 10 years ago in reply to BarryG

Hi, I saw that one but Im struggling with the syntax. I've tried to copy word for word but I get Syntax error.. (see attach)
[:S]
- Capture.jpg
- View
- Hide
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Install with active trunk VLAN port

Submitted a Tech Support Case lately from the Support Portal?