Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 7 replies
  • Subscribers 2 subscribers
  • Views 3664 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM with ESXI - Multiple NIC troubles

sculpey
Hi I have installed UTM on ESXI 5.5 in our lab with 3 NICs. All three NICs show up in the UTM and all three NICs are allocated to UTM VM in vSphere.

The problem I am running into is that I am accessing the UTM via the LAN NIC and do not have the other two NICs physically plugged with ethernet cables but according to the UTM they are up and I can access them in a browser.

Is the traffic really going across all three NICs because they are virtual? I can't figure out what is going on here, I am trying to insure that the traffic is physically separated and going through the right NICs.

Any help would be greatly appreciated.

Screen shot of ESXI NICs:
http://i57.tinypic.com/2w6ctqc.png

Screen shot of NIC Hardware in UTM:
http://i60.tinypic.com/2419iu0.png

Screen shot of interfaces in UTM:
http://i58.tinypic.com/v4v6et.png


This thread was automatically locked due to age.
Parents
  • 0
    You should install UTM with "Linux" > "Other 2.6.x Linux (64-bit)" and use VMXNET 3 as "Adapter Type".
    Obivusly, you should physically attach the WAN interface to a (external) WAN switch/gateway while using the LAN interface on the (internal) LAN switch/device.
    Also, take note of the port/use.
Reply
  • 0
    You should install UTM with "Linux" > "Other 2.6.x Linux (64-bit)" and use VMXNET 3 as "Adapter Type".
    Obivusly, you should physically attach the WAN interface to a (external) WAN switch/gateway while using the LAN interface on the (internal) LAN switch/device.
    Also, take note of the port/use.
Children
No Data
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?

Unfiltered HTML