Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 2 subscribers
  • Views 2507 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Restore HA from backup

bnhs
Hello,

I have two UTMs in HA active/standby mode.

I got a problem after an update, so i would like to restore the whole system from scratch (because my environnement isn't critical at this point, and i need to understand how to do it).

So, i formated UTM1 and restored the backup. Everything is working again.
UTM1 got back his old IP 10.10.10.100.

But how do i process to restore the HA?

On UTM1 i active the active/standby mode, I format the UTM2 and booted it. 
My UTM1 is detected a link with UTM2 because ETH3 is plugged (Do i need to plug the ETH3 yet?). 
UTM1 doesnt add UTM2 automatically. Does UTM2 need to be on the same network? Do i need to change IP and upload a licence?

Im a little confused on the exact way to process. Can you guys advise me please.[:S]


This thread was automatically locked due to age.
Parents
  • 0
    Hi bnhs;
    what version of UTM do you restore on "UTM1" ? 

    Basic steps for UTM 9.2xx:
    1)Make a fresh install on "UTM2" of the same sw version of "UTM1", without configure anything;
    2)Check that "Enable automatic configuration of new devices" flag is checked on "UTM1" under "Management/High Availability/Configuration";
    3) connect eth3 interfaces btw nodes and wait...

    Luigi
Reply
  • 0
    Hi bnhs;
    what version of UTM do you restore on "UTM1" ? 

    Basic steps for UTM 9.2xx:
    1)Make a fresh install on "UTM2" of the same sw version of "UTM1", without configure anything;
    2)Check that "Enable automatic configuration of new devices" flag is checked on "UTM1" under "Management/High Availability/Configuration";
    3) connect eth3 interfaces btw nodes and wait...

    Luigi
Children
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?

Unfiltered HTML